Setra "C" elements wrong properties
FEM-Design 24 has wrong definitions for the outer layer direction of Setra "C" elements.
They should be switched from 0 to 90 degrees.
According to support (via Christian Hervold from Norconsult) this will be fixed in FEM-Design 25.
Hi Andreas,
Thank you for your feedback regarding the Setra "C" elements in FEM-Design 24.
We appreciate you bringing this to our attention. While the fix is currently planned for version 25, we will check with our development team to see if it might be possible to prioritize the fix for an earlier release in 24.00x. We will keep you updated on any progress in this regard. Thank you again for your valuable comment.
Kind regards,
StruSoft Support